Device use and care.

1. Device cleaning. Wash with cheap bar soap. Dish soap doesn't work it leaves something slippery behind. Rubbing alcohol (IPA) doesn't seem to work very well either. I've had the best results with just cheap plain bar soap. When storing silicone devices keep them out of direct sunlight as the silicone is not UV stable it'll turn a nasty brown color and degrade.

   
   

2. Putting the device on. After cleaning and drying the device. Flip up the outer gripper. Place the car-1 on the glans. Roll skin up on to the inner gripper. You'll want to cover about 3/4 (most) of the inner gripper. Flip outer gripper down using the hand that rolled the skin up to control the gripper flip down speed. Then give it a good steady rug to help smooth out the skin under the gripper.

   
   
   
   

3. Did you notice I didn't say anything about the scar line? If you're at a low CI number don't worry about where the scar line falls. When you have more skin to work with them you can start putting the scar line at the rollover point if you want

   
   

4. Air pressure. When you inflate you do not need maximum pressure!! You want it to be squishy not rock hard. If you over inflate it you can pinch one side of the outer gripper to let some air out.

   
   

5. after inflating the CAR-1 insert one of the included plugs. the air valve will slowly leak without it.

   
   

6. My personal method for putting the car-1 on is to roll the skin up covering 100% of the inner gripper. Then when inflating I'll over inflate it so it tries to push itself off a little. Then I'll let some air out to bring it back down to a squishy air pressure.